Tag Archives: Sharpie

How to: Make a texture roller for clay

This project is instant gratification. Something that is not that common in the world of clay. With this texture roller, you can use it as soon as the hot glue has cooling, which is very fast. It’s a great project to do in a class, or on your own so you have a custom tool that no one else has.

Supplies:

  • a roller of some sort (cut up pieces of PVC, empty rolls of tape, couplings for PVC, plastic rolling pins from the dollar store or craft store).
  • a sharpie.
  • a hot glue gun. They only cost a couple of bucks.
  • extra hot glue sticks.

Draw your pattern onto the rolling pin. It’s easier to work out the pattern before with a Sharpie than it is later with the hot glue. Think about some sort of connected pattern, they tend to have the best results. And don’t go overboard with the lines, you’ll regret it later. And remember that the hot glue line aren’t going to be perfect, so just go with the imperfection.

While you’re drawing, plug in your hot glue gun. Make sure that you do it on a surface that you can toss when done, like newspaper or cardboard. When you’re done drawing on your design, start gluing. Be a bit heavy handed with the glue. If the lines are too thin, they won’t show up on the clay as well.

After the glue seems cool, start rolling away… The first attempt might stick a bit, but after there is some dusty clay on the roller, it won’t really stick.

If you’re not a hand builder, a nice use for one of these textured slabs is in the bottom of a thrown and altered casserole.

How to: Make a Foam Bat

A foam bat is endlessly helpful for trimming large pieces, and having a soft surface to work with altered pieces on.

You will need:
*A new clean bat. I used a 22″ Hydra Bat from Continental Clay.
*High density foam (it won’t flatten out when you put a heavy piece on it).
*A can of spray adhesive.
*An electric knife.
*A Sharpie or any permanent marker.

Take the bat outside and spray the bottom of it with spray adhesive.

 

Spray one side of the foam with spray adhesive. Put the adhesive sides together and press evenly.

 

Put the bat, bat side up on a banding wheel and cut off excessive foam with the electric knife. This will give you a nice clean edge.

 

Place the bat on your wheel using bat pins to ensure it’s perfectly centered. Use your marker and ruler to make concentric circles. 
Until you get to the outside edge. 
Then trim away!